Comtech EF Data CDM-500 Specifications Page 84
- Page / 88
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Rev. 1.3 i–1
I
Index
- A -
Address................................................... B–4
Alarms Connector .................................. 5–2
Approvals............................................... A–3
Auxiliary Serial Connector .................... 5–3
- B -
Basic Protocol ........................................ B–2
Buffer Disabled...................................... 7–2
Buffer Enabled, Rx<>Tx........................ 7–2
Buffer Enabled, Rx=Tx.......................... 7–2
- C -
CONFIG) FRAME (Framing Mode) ..... 6–12
CONFIG) IMPED (IF impedance)......... 6–18
CONFIG) INTFC (Interface) ................. 6–14
CONFIG) MASK (Alarm mask)........... 6–16
CONFIG) REMCONT (Remote control)6–14
CONFIG) RX (Receive)........................ 6–8
CONFIG) TX (Transmit) ...................... 6–5
CONFIG, FRAME) FRAMED .............. 6–12
CONFIG, FRAME) TRANSPARENT .. 6–12
CONFIG, MASK) AGC........................ 6–16
CONFIG, MASK) BUF-SLIP................ 6–17
CONFIG, MASK) Eb/No....................... 6–17
CONFIG, MASK) RX-AIS.................... 6–17
CONFIG, MASK) TX-AIS .................... 6–18
CONFIG, RX) ACQ.............................. 6–10
CONFIG, RX) DATA (Data Rate) ....... 6–9
CONFIG, RX) DESCRAM................... 6–10
CONFIG, RX) FEC............................... 6–9
CONFIG, RX) FRQ (Frequency)...........6–9
CONFIG, RX) MOD (Modulation).......6–8
CONFIG, RX) BUF (Buffer size)...........6–11
CONFIG, RX) CLK (Clocking)..............6–10
CONFIG, RX) Eb/No (Eb/No Alarm)....6–12
CONFIG, RX) RSI .................................6–11
CONFIG, TX) CLK (Clocking).............6–7
CONFIG, TX) DATA (Data Rate) ........6–5
CONFIG, TX) FEC................................6–6
CONFIG, TX) FREQ (Frequency) ........6–5
CONFIG, TX) MOD (Modulation) .......6–5
CONFIG, TX) ON/OFF.........................6–6
CONFIG, TX) PWR (Power) ................6–7
CONFIG, TX) SCRAM (Scrambling)...6–7
CONFIG, TX) TSI.................................6–8
CONFIG:.................................................6–4
Configuration..........................................2–2
Connect External Cables.........................2–2
Connector Pinouts...................................5–1
- D -
Data Connector .......................................5–1
Data Interfaces ........................................A–3
Demodulator ...........................................A–2
Description..............................................6–1
Disclaimer...............................................viii
- E -
EIA-232...................................................B–2
EIA-485...................................................B–1
Electrical Safety......................................vi
EMC (Electromagnetic Compatibility)...vii
- CDM-500 1
- Customer Support 4
- Table of Contents 6
- Rev. 1.3 iii 8
- Rev. 1.3 v 10
- Figures 11
- About this Manual 12
- Conventions and References 12
- Cautions and Warnings 12
- Metric Conversion 12
- BEFORE INSTALLATION AND USE 13
- Installation 14
- Warranty Policy 15
- Limitations of Warranty 15
- Exclusive Remedies 15
- Disclaimer 15
- Chapter 1 16
- INTRODUCTION 16
- 1–2 Rev. 1.3 17
- Chapter 2 18
- INSTALLATION 18
- 2.2 Configuration 19
- 2.3 Select Internal IF Loop 19
- 2.4 Connect External Cables 19
- Chapter 3 20
- FUNCTION 20
- 3–2 Rev. 1.3 21
- Chapter 4 22
- PHYSICAL DESCRIPTION 22
- 4.2 Rear Panel 24
- 4–4 Rev. 1.3 25
- Chapter 5 26
- CONNECTOR PINOUTS 26
- 5–4 Rev. 1.3 29
- Chapter 6 30
- FRONT PANEL OPERATION 30
- 6.2 Menu Trees 32
- 6.3 OPENING SCREEN 33
- 6.4 SELECT 33
- 6.5 CONFIG: 34
- 6.5.6 (CONFIG, TX) ON/OFF 35
- Rev. 1.3 6–7 36
- 6–8 Rev. 1.3 37
- Rev. 1.3 6–9 38
- 6–10 Rev. 1.3 39
- Rev. 1.3 6–11 40
- 6.5.30 (CONFIG, LOCAL) 41
- 6.5.31 (CONFIG, REMOTE) 41
- Rev. 1.3 6–13 42
- 6.5.37 (CONFIG, MASK) AGC 43
- 6.5.38 (CONFIG, MASK) Eb/No 43
- Rev. 1.3 6–15 44
- 6.6 TEST 45
- 6.7 INFO (Information) 46
- 6–18 Rev. 1.3 47
- Rev. 1.3 6–19 48
- 6.8 MONIT (Monitor) 49
- 6.8.1 (MONIT) ALARMS 49
- 6.8.5 (MONIT) STORED EVENTS 50
- 6.8.6 (MON, EVENTS) VIEW 50
- 6–22 Rev. 1.3 51
- 6.9 STORE/LD (Store/Load) 52
- 6.9.1 (STORE/LD) STORE 52
- 6.9.2 (STO/LD) LOAD 52
- 6–24 Rev. 1.3 53
- 6.10 UTIL (Utility) 54
- 6–26 Rev. 1.3 55
- Chapter 7 56
- CLOCKING 56
- 7–2 Rev. 1.3 57
- Chapter 8 58
- EDMAC CHANNEL 58
- 8.2 M&C Connection 59
- 8.3 Setup Summary 60
- 8–4 Rev. 1.3 61
- Appendix A 62
- SUMMARY OF SPECIFICATIONS 62
- A.2 Demodulator 63
- A.3 Data Interfaces 64
- A.4 Miscellaneous 64
- A.5 Approvals 64
- A–4 Rev. 1.3 65
- Appendix B 66
- REMOTE CONTROL 66
- B.3 EIA-232 67
- B.4 Basic Protocol 67
- B.5 Packet Structure 68
- B.5.1 Start Of Packet 68
- B.5.2 Address 68
- B.5.3 Instruction Code 69
- B.5.5 Message Arguments 70
- B.5.6 End Of Packet 70
- B–6 Rev. 1.3 71
- B–18 Rev. 1.3 83
- Rev. 1.3 i–1 84
- METRIC CONVERSIONS 86
- Units of Length 86
- Temperature Conversions 86
- Units of Weight 86
Related products and manuals for Networking Comtech EF Data CDM-500
(176 pages)© 2020, manymanuals.com. All rights reserved. | 0.048 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals